Festo EHMB Notice D'utilisation page 24

EHMB
3. Push the aligned rod eye aJ onto the
connecting bolt aA on the EHMB.
4. Screw in four screws to mount the
cylinder retainer (Z).
The cylinder retainer can also be mounted
on the sides (A) and (C) of the EHMB.
To attach it to the side (A), the front cover
of the EHMB must be removed. The
tightening torque for the cylinder retainer
is summarised in the table below.
EHMB−...
Screw
Tightening torque
Centring sleeve
Fig. 8
Carrying out the product installation
Note
External stops can cause the toothed belt to tear due to excessive forces.
· Use only the motor controller to brake the rotation.
Note
Eccentric masses can destroy the bearing.
· Note that the front side (A) (è Fig. 9) is permissible only for attachment with
a symmetric applied load.
· Position the EHMB so that your control sections are accessible.
· Fasten the EHMB to the threaded hole with 4 screws and 2 centring sleeves or
with the aid of kits.
24
(Z)
aJ
aA
Fig. 7
20
M4
[Nm] 2.9
dia. 7x3
(C)
25 32
M4 M5
2.9 5.9
dia. 7x3 dia. 9x4
Festo EHMB 0912NH English
(A)