Adjusting The Saw Prior To Use - Hitachi C 7UR Instructions De Sécurité Et Mode D'emploi

English
ADJUSTSING THE SAW PRIOR TO USE
WARNING:
To avoid serious accidents, ensure the switch is in OFF position, and disconnect the plug from the
receptacle.
1. Adjusting the cutting depth (Fig. 7)
WARNING:
If the lever (A) is loose, injury can result. Tighten it securely after
adjustment.
To adjust cutting depth, loosen the lever (A) and, while holding the base
with one hand, move the main body up and down to obtain the prescribed
cutting depth. After adjusting to the prescribed cutting depth, tighten the
lever (A) securely.
2. Adjusting the angle of inclination
WARNING:
If the lever (A) is loose, injury can result. Tighten it securely after adjustment.
You can incline saw blade from 0˚ to a maximum angle of 55˚ in relation to the base.
As shown in Fig. 8 by loosing the lever (A) on the bevel scale, the saw blade may be inclined to an angle of 45˚ in
relation to the base.
If you use inclination angle of over 45˚, as shown in Fig. 9 move the lever (A) to outside, the saw blade may be inclined
to a maximum angle of 55˚ in relation to the base.
Always ensure that the lever (A) is thoroughly tightened after making the desired adjustment.
Lever (A)
Fig. 8
12
0˚ – 45˚
Loosen
Tighten
Link
Lever (A)
Fig. 7
45˚ – 55˚
Fig. 9
Base