Start-Up And Run-Down Parameters; Start-Up Stage And Start-Up Time; Braking Stage And Run-Down Time; Brake Switch-Off Speed - Hettich ROTINA 420 Mode D'emploi

EN
18.5

Start-up and run-down parameters

The set start-up and run-down parameters are displayed.
x: 1-9 = start-up stage, t = start-up time
y y: 1-9 = braking stage, 0 = unbraked run-down, t = run-down time
x
18.5.1

Start-up stage and start-up time

It is only possible to set start-up times if these have been activated. See the chapter "Activating or deactivating
start-up and run-down times".

Press the key. The parameter
= start-up stage, t = start-up time
Press the key to switch between the start-up stage and start-up time.
TIME

Set the desired stage or time with the rotary knob .

If necessary, press the

To apply the setting to the display, either press the
the centrifugation data are displayed.
18.5.2

Braking stage and run-down time

No B-brake stages can be set for this device. The activation of the B-brake stages in the "Settings" menu is
not possible (parameter B-Ramp = off). B-brake stages are similar to an exponential braking curve.
It is only possible to set run-down times if these have been activated. See the chapter "Activating or
deactivating start-up and run-down times".

Press the key until the parameter
= braking stage = B- braking stage,
Press the key to switch between the braking stage and run-down time.
TIME

Set the desired stage or time with the rotary knob .

If necessary, press the

To apply the setting to the display, either press the
the centrifugation data are displayed.
18.5.3

Brake switch-off speed


Press the key as often as necessary until the parameter N Brake is shown.

Use the adjusting knob

Press the or
START
18.6

Temperature (only for centrifuge with refrigeration)

The temperature can be entered in degrees Celsius (°C) or in degrees Fahrenheit (°F). For setting the
temperature unit, see chapter "Set temperature unit".
If degrees Fahrenheit (°F) is set as the unit of temperature, the letter "F" appears after the temperature value
on the display.

Press the key. The following parameters are displayed: T/°C or T/°F.
T/°C

Use the adjusting knob

Press the key, to have the settings applied to the display.
START

Press the or
T/°C START
64/195
or is displayed.
t
key to set the next parameter.
START
or is displayed.
t
t = run-down time
key to set the next parameter.
START
to set the value you want.
keys to apply the setting to the display.
to set the value you want.
keys to apply the setting to the display
Rev. 12 / 04.2020
key or press the key as often as is required until
key or press the key as often as is required until
AB4701DEENFRIT