Ryobi RLT254CDSO Manuel D'utilisation page 27

SPARK PLUG REPLACEMENT
See fi gure 10.
WARNING
The material of the spark plug is metal. It becomes very
hot after you stop the engine. Wait for the engine to cool
down before disassembling the metal spark plug boot to
avoid personal injury.
NOTE: This engine uses a Champion RCJ-6Y or
equivalent with 0.63 mm (0.025 in.) electrode gap. Use an
exact replacement and replace annually.
1. Stop the engine.
2. Hold the front portion of the rubber protect boot and
pull it away from the housing.
3. Pull the rubber protect boot upward to release the
hook.
4. Twist the metal spark plug boot and pull it away from
the spark plug.
5. Loosen the spark plug by turning it counter clockwise
with a wrench. Remove the old spark plug and replace
with a new one. Assemble back the metal spark plug
boot and the rubber protect boot.
ATTACHING THE HANGER CAP
See fi gure 11.
To use the hanger cap, push in the button and place the
hanger cap over the lower end of the attachment. Slightly
rotate the cap from side to side until the button locks into
place.
NOTE: The secondary hole in the attachment shaft can be
used for hanging purposes as well.
STORAGE (1 MONTH OR LONGER)
■ Drain all fuel from tank into a container approved for
petrol. Run engine until it stops.
■ Clean all foreign material from the product. Store it in
a well-ventilated place that is inaccessible to children.
Keep away from corrosive agents such as garden
chemicals and de-icing salts.
■ Abide by all ISO and local regulations for the safe
storage and handling of fuel. Excess fuel should be
used in other 2-cycle engine powered equipment.
English (Original instructions)
25