ZANKER KBB29001SK Notice D'utilisation page 24

x
If necessary cut the adhe-
sive sealing strip and then
apply it to the appliance
as shown in figure.
Remove the correct part
from the hinge cover (E).
Make sure to remove the
part DX, in the case of
right hinge, SX in opposite
case.
24
x
Install the appliance in the
niche.
Push the appliance in the
direction of the arrows (1)
until the upper gap cover
stops against the kitchen
furniture.
Push the appliance in the
direction of the arrows (2)
against the cupboard on
the opposite side of the
hinge.
C
D
E
Attach the covers (C, D) to
the lugs and the hinge
holes.
Install the vent grille (B).
Attach the hinge covers
(E) to the hinge.
2
4mm
1
44mm
Adjust the appliance in the
niche.
Make sure that the dis-
tance between the appli-
ance and the cupboard
front-edge is 44 mm.
The lower hinge cover (in
the accessories bag)
makes sure that the dis-
tance between the appli-
ance and the kitchen furni-
ture is correct.
Make sure that the clear-
ance between the appli-
ance and the cupboard is
4 mm.
Open the door. Put the
lower hinge cover in posi-
tion.
E
B
Connect the appliance lat-
erally to the kitchen furni-
ture sidewall:
1. Loosen the screws of
the part (G) and
move the part (G) till
the furniture sidewall.
2. Tighten the screws of
the part (G) again.
3. Attach the part (H) to
the part (G).
Attach the appliance to
the niche with 4 screws.
Ha
G
H
Hc
Disconnect the parts (Ha),
(Hb), (Hc) and (Hd).
I
I
Hb
Hd