ZANKER KBB29001SK Notice D'utilisation page 21

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Important! There are some sounds during normal use
(compressor, refrigerant circulation).
Problem
The appliance does not oper-
ate. The lamp does not oper-
ate.
The lamp does not work.
The compressor operates
continually.
Water flows on the rear plate
of the refrigerator.
Water flows into the refrigera-
tor.
Water flows on the ground.
The temperature in the appli-
ance is too low.
The temperature in the appli-
ance is too high.
Possible cause
The appliance is switched off.
The mains plug is not connected to
the mains socket correctly.
The appliance has no power. There
is no voltage in the mains socket.
The lamp is in stand-by.
The lamp is defective.
The temperature is not set correctly.
The door is not closed correctly.
The door has been opened too fre-
quently.
The product temperature is too high.
The room temperature is too high.
During the automatic defrosting proc-
ess, frost defrosts on the rear plate.
The water outlet is clogged.
Products prevent that water flows in-
to the water collector.
The melting water outlet does not
flow in the evaporative tray above
the compressor.
The temperature regulator is not set
correctly.
The temperature regulator is not set
correctly.
The door is not closed correctly.
The product temperature is too high.
Many products are stored at the
same time.
Solution
Switch on the appliance.
Connect the mains plug to the mains
socket correctly.
Connect a different electrical appli-
ance to the mains socket.
Contact a qualified electrician.
Close and open the door.
Refer to "Replacing the lamp".
Set a higher temperature.
Refer to "Closing the door".
Do not keep the door open longer than
necessary.
Let the product temperature decrease
to room temperature before storage.
Decrease the room temperature.
This is correct.
Clean the water outlet.
Make sure that products do not touch
the rear plate.
Attach the melting water outlet to the
evaporative tray.
Set a higher temperature.
Set a lower temperature.
Refer to "Closing the door".
Let the product temperature decrease
to room temperature before storage.
Store less products at the same time.
21

Publicité

Table des Matières
loading

Table des Matières