KitchenAid 740-0781 Instructions D'installation Et Guide D'utilisation Et D'entretien page 16

Change the Infrared Searing Main Burner Orifices
1. Remove the screw securing the infrared searing main
burner igniter and remove the igniter from the searing
burner.
2. Remove the infrared searing main burner cover screws.
Set the screws and cover aside.
A.
3. Remove the infrared searing main burner from firebox.
A. Screw
A
2 Screws
3. Use a 6 mm socket and wrench or 6 mm nut driver to
remove the LP gas orifice on the end of valve. Replace
with natural gas orifice.
A
4. Reinstall infrared searing main burner. Make sure that the
igniter is out of the way to allow proper positioning of
burner. Use a Phillips screwdriver to attach the mounting
screws.
5. Use a Phillips screwdriver to reattach the igniter and
infrared searing main burner plate.
6. Reinstall infrared searing main burner cover. Use a Phillips
screwdriver to attach mounting screws.
7. Open the manual shutoff valve in the gas supply line. The
valve is open when the handle is parallel to the gas pipe.
8. Test all connections by brushing on an approved
noncorrosive leakdetection solution. Bubbles will show a
leak. Correct any leak found.
The igniter battery is not factory installed. A "AA" size
9.
alkaline battery is located in the accessory box on the grill
grate. Install battery at this time following the instructions
in "Replacing the Igniter Battery" section.
10. Go to "Check and Adjust the Burners" section.
Record Conversion
The LP appliance nameplate is located inside the grill cabinet
on the left-hand side. Once converted, place the NG appliance
nameplate as close as possible to the current LP appliance
nameplate without covering it.
In the last page of the Use and Care Guide, write "Converted to
Natural Gas". Also record the conversion date and the
technician/company that performed the conversion.
16
Orifice
A. Gas supply line
Shutoff valve "open" position
B.
C. To grill