Settings; Working - Festool CT 15 E HEPA Notice D'utilisation D'origine

English
7.4 Connecting power tools
WARNING
Risk of injury
► Observe the maximum electrical outlet
module connected load (see section "Tech­
nical data").
► Switch off the power tool.
Connecting a mains-powered power tool to the
mobile dust extractor
► Connect the power tool to the electrical out­
let module [1-1].
The power tool is connected to the mobile dust
extractor via the power cable.
8

Settings

8.1 Adjusting the suction power
► Press the plus or minus button [1-12] while
extracting.
8.2 Temperature cut-out
A temperature cut-out switches the mobile dust
extractor off when it reaches a critical tempera­
ture to prevent overheating. The bottom
LED [1-12] indicates a fault.
LED lights up red
► Switch off the mobile dust extractor, let it
cool down.
► Switch on the mobile dust extractor again
after approx. five minutes.
9

Working

9.1 Dust extraction
Extracting dry materials
Always use a filter bag.
9.2 Extracting wet materials/liquids
Remove the filter bag!
Use a special wet filter.
The dust extractor stops automatically when
the maximum fill level is reached.
The bottom LED [1-12] lights up red.
► Switch off the mobile dust extractor [1-10].
► Open the locking clips [1-7] and remove the
top section of the machine.
► Empty the dirt trap [1-9].
After wet extraction, allow the main filter to dry!
Dry the mobile dust extractor before extracting
dry dust.
12
Excessive temperature
CAUTION
Hazardous dust
Damage to the respiratory passage
► After extracting wet materials, remove the
wet filter and replace it with the main filter
for dry materials.
CAUTION
Escaping foam and fluids
► Switch off and empty the machine immedi­
ately.
9.3 Blow-out function
► Open the grille in front of the exhaust open­
ing [1-8].
► Insert the suction hose in the exhaust open­
ing [1-8].
► In standby mode, press the MAN but­
ton [1-11].
9.4 Changing the filter bag with minimal
dust
► Open the locking clips and remove the top
section of the machine [2].
► Pull the tab on the filter bag until the filter
bag opening is fully closed.
The filter bag is now securely closed and can be
removed.
► Fit the top section of the machine and close
the locking clips.
9.5 Changing the filter element [6]
► Pull out the used filter drawer [1-6].
► Dispose of the used filter drawer in accord­
ance with statutory regulations.
► Insert the new filter drawer [1-6].
Order numbers for accessories, filters and
consumables in the Festool catalogue or
online at "www.festool.com".
Only use original Festool accessories and
–
consumables. Only accessories tested and
approved by Festool are safe and perfectly
adapted to the machine and application.
NOTICE
Damage to the motor
► Never extract material without a main filter
or with a damaged main filter, as this can
damage the motor.