Ryobi RYi2200GR Manuel D'utilisation page 11

FUEL CAP WARNING
Never remove fuel cap when unit is running. Shut off engine and allow the
unit to cool at least five minutes. Remove cap slowly to release any pressure
built up in the fuel system and to avoid the heat from the muffler igniting
fuel vapors.
ENGINE LUBRICANT WARNING
You must add lubricant before first operating the generator. Always check
the lubricant level before each operation. The lubricant level should always
register between the hatched areas on the dipstick. The unit is equipped
with a sensor which will automatically shut off the engine if the lubricant
level falls below a safe limit.
GROUNDING WARNING
This generator does not include a ground rod or copper wire. Call a quali-
fied electrician for local grounding requirements.
CLEARANCE WARNING
While operating and storing, keep at least 3 feet of clearance on all sides of
this product, including overhead. Allow a minimum of 30 minutes of "cool
down" time before storage. Heat created by muffler and exhaust gases
could be hot enough to
cause serious burns and/or
ignite combustible objects.
SPARK ARRESTOR
Operation of this equipment may create sparks that can
start fires around dry vegetation. A spark arrestor may be
required. The operator should contact local fire agencies for
laws or regulations relating to fire prevention requirements.
SYMBOLS
HOT SURFACE WARNING
Do not touch the muffler or aluminum cylinder of the engine.
They are very HOT and will cause severe burns. Don't put
body parts or any flammable or combustible materials in the
direct path of the exhaust.
7 — English