Sony DSX-B710D Mode D'emploi page 14

Mounting the unit in the dashboard
For Japanese cars, see "Mounting the unit in a
Japanese car" (page 14).
Mounting the unit with the supplied
mounting sleeve
Before installing, make sure the catches on both
sides of the mounting sleeve  are bent inwards
3.5 mm ( 5 / in).
32
1
Position the mounting sleeve  inside
the dashboard, then bend the claws
outward for a tight fit.

2
Mount the unit onto the mounting
sleeve .

Note
If the catches are straight or bent outwards, the unit will
not be installed securely and may spring out.
14
GB
Larger than
Catch
182 mm (7 1 /
4
Larger than
111 mm
(4 3 / in)
8

Mounting the unit in a Japanese car
You may not be able to install this unit in some
makes of Japanese cars. In such a case, consult your
Sony dealer.

Bracket
Parts supplied with
your car
When mounting this unit to the preinstalled
brackets of your car, use the mounting screws  in
the appropriate screw holes based on your car:
T for TOYOTA and N for NISSAN.
in)
Note
To prevent malfunction, install only with the mounting
screws .
Resetting the unit
For details, see "Resetting the Unit" (page 6).
Fuse replacement
When replacing the fuse, be sure
to use one matching the
amperage rating stated on the
original fuse. If the fuse blows,
check the power connection and
replace the fuse. If the fuse blows
again after replacement, there
may be an internal malfunction. In such a case,
consult your nearest Sony dealer.
To dashboard/center console
Bracket
Fuse (10 A)
