Tecno-gaz KYRI Mode D'emploi page 24

ENGLISH
8 OPERATING INSTRUCTIONS
8.1 Electrical movements and memories
The chair can be moved in 4 ways by means of 4 independent electrical actuators:
Chair up and down movement
Press button 18 or 16 on the footboard to move the chair down or up.
Back movement
Press button 12 or 14 to move the back up or down.
Seat movement
Press button 13 or 15 to move the seat down or up at an angle of up to 20°.
Leg guard movement
Press button 17 or 19 to move the leg guard down or up level with the seat.
Memories
The chair has two positions that can be chosen at will and saved as M1 and M2, and a
RINSING position that can also be saved.
To save a position, simply perform the required movement and then press and hold the
position of the required memory for a minimum of two seconds. Two beeps confirm that
the position has been saved. To select a memory, simply press M1, M2 or Rinsing; a beep
indicates the saved movement has been completed.
ATTENTION! To stop the chair before it reaches the saved position, simply press one of
the buttons on the footboard.
Return to zero memory
The chair also has a memory for automatic return to the zero position (the chair all the way
down and the back fully upright) to allow the patient to climb off the chair easily. A beep
indicates the saved movement has been completed.
N.B. In order to guarantee the precision of the memories over time, it is advisable to use
the return to zero memory function as often as possible during the day.
N.B. In the case of a WIRELESS pedal, the LED will flash when the battery is low; to
recharge the battery, simply connect the battery charger provided with the footboard and
press any button; the LED starts flashing slowly and remains steady when the battery is
fully charged.
10