Power Cord Connection - Pioneer PDP-5004 Mode D'emploi

Installation and Connections
Audio connection for component connected to
INPUT3
INPUT3
AUDIO
R L
The audio line for the component connected to INPUT3
can be connected to the Audio R/L (INPUT3) pin jacks.
Sound is output from the SPEAKER (L/R) terminals
according to the video input selection.
Audio connection for component connected to
INPUT4
INPUT4
AUDIO
R L
The audio line for the component connected to INPUT4
can be connected to the AUDIO R/L (INPUT4) pin jacks.
Sound is output from the SPEAKER (L/R) terminals
according to the video input selection.
18
EN
Audio connection for component connected to
INPUT5
INPUT5
AUDIO
R L
The audio line for the component connected to INPUT5
can be connected to the AUDIO R/L (INPUT5) pin jacks.
Sound is output from the SPEAKER (L/R) terminals
according to the video input selection.

Power Cord Connection

Connect the power cord after all component connections
have been completed.
1
Connect the power cord to this unit.
2
Plug the power cord into a power outlet.
CAUTION
÷ Use only the power cord provided.
÷ For the plasma display, a three-core power cord with a ground
terminal is used for efficiency protection. Always be sure to
connect the power cord to a three-pronged grounded outlet
and make sure that the cord is properly grounded. If you use a
power source converter plug, use an outlet with a ground
terminal and screw down the ground line.
NO!
÷ Do not use a power supply voltage other than that indicated
(AC 120 V, 60 Hz) as this may cause fire or electric shock.