Pioneer PDP-5004 Mode D'emploi page 17

Connection to AV components
Connection to AV component equipped with
component video jacks
Make component video connections for AV components
equipped with component video jacks.
When connecting to ANALOG RGB IN (INPUT1)
ANALOG RGB IN
AUDIO
INPUT1
INPUT1
D-Sub
R L
On-screen setup is necessary after connection.
Please see pages 21 to 23.
When connecting to COMPONENT VIDEO (INPUT5)
COMPONENT
INPUT5
VIDEO
Y C /P C /P
B B R R
Connect the Y signal to the Y jack, the C
C /P jack, and the C /P signal to the C
B B R R
Note
This unit is designed to support component video signals with
standard, stable signal levels and sync signals. As a result, some
image disruption may be generated during use of various special
trick play functions on video components.
Connection of G ON SYNC analog RGB source
Make G ON SYNC connections for a component with
output that has the synchronization signal layered on top
of the green signal.
When connecting to ANALOG RGB IN (INPUT1)
On-screen setup is necessary after connection.
Please see pages 21 to 23.
When connecting to COMPONENT VIDEO (INPUT5)
Connect the G ON SYNC signal to the Y jack, the B signal
to the C
/P signal to the
B B
On-screen setup is necessary after connection.
/P jack.
R R
Please see pages 21 to 23.
Installation and Connections
ANALOG RGB IN
AUDIO
INPUT1
INPUT1
D-Sub
R L
COMPONENT
INPUT5
VIDEO
Y C /P C /P
B B R R
/P jack, and the R signal to the C
B B
/P jack.
R R
13
EN