GE 162D9617P005 Manuel D'utilisation page 27

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Shut Off the Main Water Supply
Turn on the nearest faucet long enough to clear the line of water.
Install the Shutoff Valve
Install the shutoff valve on the nearest
1
frequently used drinking water line.
Choose a location for the valve that is easily
2
accessible. It is best to connect into the side of a
vertical water pipe. When it is necessary to
connect into a horizontal water pipe, make the
connection to the top or side, rather than at the
bottom, to avoid drawing off any sediment from
the water pipe.
Drill a 1/4² hole in the water pipe, using a sharp
3
bit. Remove any burrs resulting from drilling the
hole in the pipe.
Fasten the shutoff valve to the cold water pipe
4
with the pipe clamp.
Tighten the clamp screws until the sealing
5
washer begins to swell.
Route the Copper Tubing and Connect It to the Shutoff Valve
Route the copper tubing between the cold water
line and the refrigerator.
Route the tubing through a hole drilled in the wall
or floor (behind the refrigerator or adjacent base
cabinet) as close to the wall as possible.
Be sure there is sufficient extra tubing [about 8
feet (244 cm) coiled into 3 turns of about 10²
(25 cm) diameter] to allow the refrigerator to
move out from the wall after installation.
Place the compression nut and ferrule (sleeve)
onto the end of the tubing and connect it to the
shutoff valve.
Make sure the tubing is fully inserted into the valve.
Tighten the compression nut securely.
Turn On the Water and Flush Out the Tubing
Turn the main water supply on and flush out the
1
tubing until the water is clear.
Do not overtighten or you may crush the copper
tubing.
Washer
Pipe Clamp
Saddle-Type
Shutoff Valve
NOTE: Commonwealth of Massachusetts Plumbing Codes
248CMR shall be adhered to. Saddle valves are illegal and
use is not permitted in Massachusetts. Consult with your
licensed plumber.
Saddle-Type Shutoff Valve
Packing Nut
Outlet Valve
NOTE: Commonwealth of Massachusetts Plumbing Codes
248CMR shall be adhered to. Saddle valves are illegal and
use is not permitted in Massachusetts. Consult with your
licensed plumber.
Shut the water off at the water valve after about
2
one quart (1 L) of water has been flushed
through the tubing.
Inlet End
Vertical Cold Water Pipe
Compression Nut
Ferrule (sleeve)
27

Publicité

Table des Matières
loading

Table des Matières