Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
EN
Gratulation for your new HAWK III. This is the third version of the famous F5B Hotliner from Staufenbiel.
The fuselage is now reinforced with Carbon and got air in and outlets. For a better visibility the design
is changed to Neon. The HAWK III is available in two versions. Several steps in this manual are done
in the PNP Version and are only for the ARF Version. These steps are marked with ONLY ARF Version.
Please note that some of the steps and ways to build are on the decision of the modeller and
should be seen as proposal.
Please read this manual carefully before start assembling the modell.
In the box ARF-Version:
Painted fuselage and wing, elevator, small
parts.
Needed for the ARF-Version:
4-5 Channel Transmitter , Motor, ESC, 3S or
4S LiPo Battery, Charger, CA, Activator, 5
Minute Epoxy, Loctite, UHU Endfest 3000,
Velcrotape, Cablestraps, 3 x Servoexten-
sioncable 45cm, 2 Servoextensioncable
20cm, 1 pair MPX Connectors, Turbo Spin-
ner, Folding prop, Z-Bends.
18
PREFACE
SET CONTENT
Content PNP-Version:
Painted fuselage, painted wing, elevator,
small parts, black anodized spinner, CAM
Carbon Folding prop. Motor installed, ser-
vos installed.
Needed for the PNP-Version:
4-5 Channel transmitter, 3S or 4S LiPo Bat-
tery, Charger , CA Glue, Aktiviator, 5 Min
Epoxy, Loctite, UHU Endfest 300, Velcro
Tape, cable connectors
Publicité
Table des Matières
