How To Use - Hitachi DH 28PC Mode D'emploi Et Instructions De Securite

English
Please replace the drill bit after removing
dust collector (B).
8. Selecting the driver bit
Screw heads or bits will be damaged
unless a bit appropriate for the screw
diameter is employed to drive in the
screws.
9. Confirm the direction of bit rotation
(Fig. 6)
The bit rotates clockwise (viewed from
the rear side) by pushing the R-side of
the push button. The L-side of the push
button is pushed to turn the bit
counterclockwise.
Push button
L
Fig. 6
10.Selecting the function mode
You can switch functions to the 3 modes
of "hammering only, "rotation +
hammering", and "rotation only" by
turning the change lever while pressing
the push button. Set the
of the change lever to that of the mode
to be used.
CAUTION:
Before operating the change lever, check
and make sure that the motor has
stopped.
A failure can occur if it is operated while
the motor is running.
To operate the change lever, press the
push button, and release the lock of the
change lever. Also, check and make sure
after operation that the push button has
returned and that the change lever has
been locked.
10

HOW TO USE

R
NOTE:
1. Switch operation
2. Rotation + Hammering
mark position
Switch the change lever without
mistake. If it is used at a position
halfway, there is a fear that the service
life of the switching mechanism may be
shortened.
CAUTION:
To prevent accidents, make sure to turn
the switch off and disconnect the plug
from the receptacle when the drill bits
and other various parts are installed or
removed. The power switch should also
be turned off during a work break and
after work.
Ensure that the wing bolt in the side
handle is properly tightened before
using the tool.
The rotation speed of the drill bit can be
controlled steplessly by varying the
amount that the trigger switch is pulled.
Speed is low when the trigger switch is
pulled slightly and increases as the
switch is pulled more. To turn the switch
OFF, release the trigger switch to its
original position.
This rotary hammer can be set to
rotation and hammering mode by
pressing the push button and turning the
change lever to
Turn the grip slightly and confirm that the
clutch has been engaged with a click.
Change lever
Fig. 7
mark. (Fig. 4)
Push button