Bionest SA-3 Guide D'utilisation page 43

BIONEST® reactor
Air pump
The filter of each air pump must be cleaned periodically. According to the air pumps location
(dusty area), a more frequent cleaning by the owner may become necessary; a clogged filter may
cause overheating or pump failure. To clean the air filter:
1. Disconnect the air pump and BIOLARM® power supplies.
2. Remove the air pump cover by unscrewing the screw and pulling on the cover.
3. Remove and clean the filter. If required, clean with soapy water. If cleaned with water,
make sure the filter is well rinsed under clear water and dried thoroughly before
putting it back into place.
4. Install the filter and cover making sure the seal joint is positioned correctly.
Replace previously removed screw.
5. Turn on air pump and BIOLARM® power supplies.
Attention : Please make sure the air pump is installed in a well ventilated room, away
from dust.
Owner's manual SA
Screw
Cover
Filter
Pump casing
17
4
2014-10-01
DOC0014