Hoover FREESPACE EVO FV70 Manuel D'utilisation page 5

To remove the exhaust filter:
1. Unlock the door by rotating the door along arrows indicated [21].
2. Remove the filter pack from the recess [22].
Gently tap and wash the filter packs using hand warm water [23]. Remove excess water from the
filters with a dry cloth and leave to dry fully before re-using. Reassemble filter packs once fully
dry and refit to the cleaner.
Remember: Do not use hot water or detergents. In the unlikely event of the filters becoming
damaged, fit a Genuine Hoover consumable. Do not try and use the product without a dust bag
or filter fitted.
Cleaning the permanent dust bag (depending on model)
To maintain optimum performance we recommend that you wash the permanent bag after
every 5 full bags. Empty the contents of the Bag into a bin, wash the Bag under handwarm
water, remove excess water with a dry cloth and leave to dry fully before replacing.
Removing a Blockage From The System
If the bag check indicator is red:
1. Check if the bag is full. If so refer to 'Replacing The Dust Bag' .
2. If it is not full, then;
A Do the filters need cleaning? If so refer to 'Cleaning the Filter' .
B. Check if there is any other blockage in the system - Use a rod or a pole to remove any
blockage from the telescopic tube or flexible hose.
C. Check for and clear any blockage in the Nozzle.
warning - The bag check indicator will turn red if the cleaner is used when full, if there is a
blockage or if the filters are dirty. If the cleaner is used for a significant period of time with the
bag check indicator is red, a thermal cut out will switch the cleaner off to prevent overheating.
The bag check indicator turn green once the cleaner has switched off to signal that the
thermal cut out has been activated. If this should happen, switch the cleaner off, unplug and
correct the fault. It will take about 45 minutes for the cut out to automatically reset.
ACCESSORIES
To obtain the best performance and energy efficiency
nozzles are used for the main cleaning operations. These nozzles are indicated in the diagrams
by the letters GP, HF or CA.
A nozzle type GP can be used to clean both carpet and hard floor.
A nozzle type HF is suitable for use only on hard floor.
A nozzle of type CA is suitable for use only on carpet.
The other nozzles are accessories for specialist cleaning tasks and are recommended for
occasional use only.
It is important to note that this vacuum cleaner is supplied with an Energy Label as required by
European Regulation (EU) 665/2013.
If the label shows a red prohibition circle on the left covering the carpet symbol, then this
indicates that the vacuum cleaner is not suitable use on carpets.
If the label shows a red prohibition circle on the right covering the hard floor symbol, then this
indicates that the vacuum cleaner is not suitable for use on hard floors.
*Certain models Only ** Certain models only, nozzles may vary according to model
#1
it is recommended that the correct
#1
NOTE: Dust pick up ability carpet, dust pick up ability hard floor, and energy efficiency in
accord with Commission Regulations (EU) 665/2013 and (EU) 666/2013.
Please see the model specification on the packaging label for inclusion of accessories to
individual models.
All accessories can be fitted to the hose handle or the end of the telescopic tube.
Crevice Tool – For corners and hard to reach areas. Remove the Crevice tool from the accessories
holder [24] and fit to the hose handle [25] or telescopic tube.
Dusting Brush – For bookshelves, frames, keyboards and other delicate areas. Remove the
dusting brush from the accessories holder [24] and fit to the crevice tool then fit to the hose
handle [25] or telescopic tube.
Parquet Nozzle* – For parquet floors and other delicate floors.[1S]
Pet Hair Remover mini Turbo Nozzle* - Use the mini turbo nozzle on stairs or for deep
cleaning on textile surfaces and other hard to clean areas. Particularly suitable for pet hairs
removal. [1T]
Allergen Remover mini Turbo Nozzle* – Use the mini turbo nozzle on stairs or for deep
cleaning on textile surfaces and other hard to clean areas. Particularly suitable for allergen
removal. [1U]
Grand Turbo Nozzle* – Use the Grand Turbo Nozzle for deep cleaning on carpets. [1V]
ImPORTANT: Do not use the Grand Turbo Nozzle or Mini Turbo Nozzles on rugs with long
fringes, animal hides and carpet pile deeper than 15mm. Do not keep the nozzle stationary
while the brush is rotating.
USER CHECklIST
should you have a problem with the product, complete this simple user checklist before calling
your local Hoover service.
• Is there a working electricity supply to the cleaner? Please check with another electrical
appliance.
• Is the Bag over-filled? Please refer to 'Cleaner Maintenance' .
• Is the filter blocked? Please refer to 'Cleaner Maintenance' .
• Is the hose or nozzle blocked? Please refer to 'Removing a blockage from the system' .
• Has the cleaner overheated? If so, it will take approximately 45 minutes to automatically reset.
ImPORTANT INFORmATION
Hoover spares and Consumables
Always replace parts with genuine Hoover spares. These are available from your local Hoover
dealer or direct from Hoover. When ordering parts always quote your model number.
Microfiber Bag
Pre-Motor Filter
Exhaust Microfilter
Complete Flexible Hose
Carpet & Floor smart Nozzle
Carpet & Floor smart Nozzle
3
H71 35601069
s107 35601057
T102 35601056
D122 35601055
G202EE 35601595
G217sE 35601610
GB