Hendi 274125 Mode D'emploi page 17

Troubleshooting
Problem Cause
Does not heat No power
Main switch (6) set to OFF
Temperature sensor activated
Temperature regulator (7) set to 0°C
Mixing paddle No power
does not turn
The driving shaft is not properly in
place
Motor fault
Main switch (6) set to OFF
Tap leaks It has not been fit correctly
The outlet and rubber are dirty
The sealing gasket needs replacing
Water is Temperature too high
escaping from
The sealing gasket of the level tube
the level tank
needs replacing
The water level is above the MAX
indication when the machine is at
room temperature
Product leaks The bowl has not been fit correctly in
from the bottom place
of the
The seal needs replacing
transparent
bowl
Machine The temperature sensor activated
shutdown
If the machine malfunctions due to causes other than those listed in this table or the proposed remedies do not solve
the problem, contact a specialized technician.
Remedy
Make sure that the machine is plugged in properly
Set the switch to -ON-
Reset the temperature sensor as directed in section 6.1.
Adjust the temperature regulator (7)
Make sure that the machine is plugged in properly
Remove the shaft and then insert it correctly as directed
in section 1.8.
Contact service personnel
Press the switch on
Empty the machine and fit the tap as directed in section
1,4.
Empty the machine and clean the entire tap throughly;
fit it back on the machine as directed in section 1.4.
Contact service personnel
Lower the temperature
Contact service personnel
Allow the machine to cool down and empty the boiler until
reaching the level indicated
Empty the machine, remove the bowl and fit in place
according to the instructions provided in section 1.3.
Contact service personnel
Unplug & let cool down the machine completely. Then,
RESET the temperature sensor according to the section
1.14.
EN
17