Hendi 274125 Mode D'emploi page 11

1.6. Disassembling the tap
• Refit the tap;
• Pour a little water inside the pan;
• Use the tap to drain out all water from the pan so
as to eliminate any small product residues inside
the dispensing channel.
To clean the inside of the tap more thoroughly, dis-
assemble it as follows:
• Remove the tap, follow the steps listed in para-
graph 1.4;
• Place the tap on a clean, flat surface, then loosen
and remove the screw (A) fastening the button to
the machine, then slide out the pin (B) and rele-
vant spring (C) from the seating.
• Pull the (D) all the way out from the knob (E) then
push the lever (F) upwards from the bottom until
it comes out from the pin guide, as illustrated in
the figure;
• Unscrew the knob (E) by turning it anticlockwise
while holding the rod in place;
• Pull out the rod (G) and spring (H) from the tap
body (the pin/gasket assembly (I) will slide out
together with the rod)
• Detach the rod (G) from the pin/gasket assembly
(I);
EN
11