Operation - Wolf Garten Lycos 40/370 M Mode D'emploi

EN
Power pack insertion (Fig.
Open the cover of the power pack compartment
.
Insert the power pack into the compartment
making sure it engages at position 2
Insert the safety key into its socket
it clockwise until it reaches position "1"
Close the cover
Power pack removal (Fig.
Risk of injuries due to the rotating mower
blade.
Only adjust the lawnmower with the
motor switched o and the mower blade
at a standstill.
Switch the motor o .
SAFETY ROUTINE
Open the cover
Turn the safety key anti-clockwise until it reaches
position "0" , then remove it.
Press the power pack release
Remove the power pack
Close the cover

Operation

Operating elements (Fig.
1 Handle
2 Operator presence control
3 Fill level indicator
4 Grass collector
5
6 Handle height adjuster
7 Cutting height adjuster
8 Cutting height indicator
9 On/off switch (switch-on preventer)
10 LED indicator
11 Safety key
12 Power pack release
13 Cover
14 Changeover switch (cut-collect/mulch)
15 Mower blade
26
)
, then turn
.
)
DANGER!
.
.
.
.
)
LED status indicator (Fig.
LED status
Steady green
Steady yellow
.
Steady red
.
Slow ashing
red
Quick ashing
red
Operating times
Observe the times stipulated in local byelaws.
Check with your local authorities to determine if
there are any operating time limitations.
Attaching the grass collector (Fig.
Risk of injuries due to the rotating mower
blade.
Switch the motor o .
Open the cover
Turn the safety key anti-clockwise until it reaches
position "0"
Press the power pack release
Put the power pack into position 1
storage and transport.
Close the cover
Raise the de ector ap
Hold the grass collector by its handle and tilt it
slightly, so that the grass collector can be attached
by its hooks in the recesses on the rear side of the
lawnmower
Hook the grass collector on to the lawnmower
.
Fold the de ector ap downwards again
Meaning
Power pack charge state
40% - 100%
Power pack charge state 5% - 40%
Power pack charge state 0% - 5%
Power pack temperature too high or
too low
Lawnmower temperature too high
Overcurrent release (or release due
to low or high voltage)
Motor sluggish or blocked.
DANGER!
Only adjust the lawnmower with the
motor switched o and the mower blade
at a standstill.
SAFETY ROUTINE
.
.
.
.
.
Operation
/10)
)
.
for
.