Assembly; Operation - Wolf Garten LI-ION POWER 34 Notice D'instruction D'origine

Masquer les pouces Voir aussi pour LI-ION POWER 34:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 18

Assembly

Fasten handle bars
A
1
Caution!
The cable can be damaged while folding up or pulling out
the handle bar.
z Inlay the cable in the bend protection
z When adjusting the handle height take care that the ca-
ble is not crimped

Operation

General
Contact key
K
1
Caution! Rotating blade
Before carrying out any adjustments:
z Remove the contact key.
z Do not touch rotating blades.
3
The mower is only powered with electricity if the con-
tact key is inserted.
Operating times
z Please check noise abatement regulations prevailing in your
country.
Instructions for the use of WOLF battery-powered
mowers
3
The area that can be mown by your battery-powered
mower is dependent on various factors. These are:
Type of lawn
Battery-powred lawnmowers are suitable for lawns the are
mown frequently, normally, and, to a certain extent, for
lawns that have not been cut for a while after holidays. The
surface area that can be mown does however decrease in
the order given above. Battery-powered mowers are not
suitable for infrequently-mown meadows or similar.
Lawn structure
The area that can be mown decreases in proportion to the
density of the grass. The mowing capability is lowest on ex-
tremely dense grass, e. g. golf greens.
Lawn condition
The condition of the lawn (dry, damp with dew, wet) has a
major influence on the area of lawn which can be mowed.If
the lawn is dry, this will give the maximum area which can
be mowed.If the lawn is wet, more energy is required for the
mowing and collection and thus this is the condition where
the area which can be mowed is at a minimum.
Mowing/walking speed
The walking speed infl uences the duration of mowing and
therefore the area that can be covered. We therefore re-
commend rapid mowing. The mowing path should not be
covered twice if possible and the overlap of mowing tracks
should be kept as minimal as possible. Frquently switching
the mower on and off likewise decreases the battery's pow-
er.
14
B
C
A
.
B
1. Fold the bottom part of the handle up and screw it tight with
the two hand wheels
C
2. Set the handle to the desired height
3. Fold the upper part of the handle out and screw it tight with the
wing nuts
C
(2).
Mount the collecting bag
z See illustrations.
Charging the battery
1
Caution! The charger must only be operated in dry
rooms!
3
General charging instructions
To prolong the service life of the battery, observe the follow-
ing instructions:
z Charge the battery before using the mower for the first
time.
z For charging times, see page 128.
z If the battery voltage is too low, the lawnmower switches
off automatically. In such a case, recharge the battery.
z The Lithium iron battery must also be recharged before
prolonged periods of non-use, for example at the begin-
ning of winter.
z The Lithium ion battery can be recharged at any charge
level, and charging can be interrupted and resumed with-
out any damage to the battery (no memory effect).
1. Remove the contact key
2. Release the battery cover by pushing it down
3. Remove the battery from the recess
4. Connect the battery to the charger
5. Connect the charger to the mains socket (230 V
3
Instructions for the handling of the charger:
z Red LED is on: Battery is being charged
z Green LED is on: Charge process completed
z If the charger is connected to a power socket without a
battery, the LEDs are off.
z In order to prolong the life the battery, it should not be
charged for a period longer than two days.
(1).
B
.
D
E
F
G H
J
K
.
L
.
M
.
N
.
)
N
~
.
G

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Li-ion power 37Li-ion power 40

Table des Matières