Overview Of Controls; Preparations Before Initial Operation; Initial Operation - Vaillant atmoMAG mini 11-0/0 XI Manuel D'utilisation

5 Operation
5 Operation
5.1

Overview of controls

9
8
5
7
Fig. 5.1 Controls
Key
1 Temperature selector
2 Ignition voltage LED (yellow)
3 Error LED (red)
4 Operation LED (green)
5 Main on/off switch
6 Cold water connection
7 Gas connection
8 Hot water connection
9 Power switch (10 levels from 50 to 100 %)
Control Meaning
Operation LED Lights up when the burner is in operation.
(green)
Error LED (red) Flashes when there is an error.
Ignition voltage Lights when the voltage in the battery drops
LED so much that safe operation can no longer be
(yellow) guaranteed.
Table 5.1 LED controls
8
5.2

Preparations before initial operation

7
Fig. 5.2 Shut-off valves
>
Open the gas stop cock (7) of the appliance by push-
ing it and turning the handle anticlockwise as far as it
will go (a quarter turn).
>
Open the shut-off valve on the cold water connection
(6) of the appliance.
>
Open the shut-off valve on the cold water connection
(6) of the appliance by turning the handle anticlock-
wise as far as it will go (a quarter turn).
5.3

Initial operation

1
If the unit's mains connection cable is damaged, it must
be replaced by the manufacturer or its customer serv-
ices department or a qualified specialist tradesman in
order to prevent any hazards.
6
2
3
4
9
Fig. 5.3 Start-up
>
Press the main switch (5) in until it catches.
>
Turn the power switch (9) to the required level. The
gas instantaneous water heater goes into standby
mode.
Operating manual atmoMAG mini 11-0/0 XI 838291_05
6
5