Bosch R418009760–BDL–001–AA/2009-07 Mode D'emploi page 83

Inverted tooth chain drive | R418009760–BDL–001–AA/2009-07
Sprocket removal
3. Insert the rivet pin lock's lock pivot (8). Then remove the
second axle pivot with the connected welding plate (17).
Ensure that the lock pivot and the rolling pivot are arranged as
shown in Table 8 on page 66.
8
Fig. 15: Inserting the lock pivot, removing the axle pivot with
connected welding plate
4. Position the rivet plate (9).
5. Rivet the rivet lock and grind the rivet head down until it is flush
with the outer surface of the welding plates.
Fig. 16: Riveting
X
Remove the sprockets from the shafts as described in the
system documentation.
Bosch Rexroth AG
Service and Repairs
17
9
81/220
00135401
00135402