Lubricating The Gearbox; Storing The Machine; Sharpening Metal Cutting Blades - Stihl FS 130 Notice D'emploi

English

Lubricating the Gearbox

1
2
Check the grease level regularly –
N
about every 25 hours of operation.
Unscrew the filler plug (1). If no
N
grease can be seen on the inside of
the filler plug, screw the tube (2) of
STIHL gear lubricant (special
accessory) into the filler hole.
Squeeze up to 5 g grease into the
N
gearbox.
NOTICE
Do not completely fill the gearbox with
grease.
Remove the tube of grease (2).
N
Refit the filler plug (1) and tighten it
N
down firmly.
34

Storing the Machine

For periods of about 3 months or longer
Drain and clean the fuel tank in a
N
well ventilated area.
Dispose of fuel properly in
N
accordance with local
environmental requirements.
Run the engine until the carburetor
N
is dry – this helps prevent the
carburetor diaphragms sticking
together.
Remove, clean and inspect the
N
cutting attachment. Coat metal
cutting attachments with corrosion
inhibitor.
Thoroughly clean the machine – pay
N
special attention to the cylinder fins
and air filter.
Store the machine in a dry and
N
secure location – out of the reach of
children and other unauthorized
persons.
Sharpening Metal Cutting
Blades
Use a sharpening file (see "Special
N
Accessories") to sharpen dull
cutting attachments. In case of
more serious wear or nicks:
Resharpen with a grinder or have
the work done by a dealer – STIHL
recommends a STIHL servicing
dealer.
Sharpen frequently, take away as
N
little metal as possible – two or three
strokes of the file are usually
enough.
1
1
2
2
1
2
2
1
Resharpen the teeth (1) uniformly –
N
do not alter the contour of the parent
blade (2) in any way.
See cutting attachment packaging for
additional sharpening instructions. Keep
the packaging for future reference.
FS 130, FS 130 R