Dometic TEC30D EV Notice D'utilisation page 15

TEC30D EV
Control elements in the control panel
The control panel is located in the generator behind the cover.
No. in
fig. 2, Description
page 3
1 Main switch
2 Battery charger fuse
3 Main fuse
Control elements in the remote control
The remote control is installed in the vehicle interior.
No. in
fig. 3, Description
page 3
1 Display
2 On/Off switch
3 START button
4 Diesel oil gauge
5 Oil gauge
EN
Technical description
Switches the generator to standby or no
function.
0: The generator is shut off from the
supply battery.
1: The generator is powered by the
supply battery and ready for start up.
Triggers if the AC voltage overloads.
Fuse needs to be replaced if it has trig-
gered.
Triggers if the AC voltage overloads.
Fuse needs to be replaced if it has trig-
gered.
Shows the status reports.
Switches the remote control on and off if
the main switch is at "1".
Stops the generator.
Starts the generator if the remote control
is switched on and the main switch is at
"1".
Lights up if the diesel oil goes into
reserve.
Lights up if the oil level is too low in the
engine.
15