Dometic CoolAir SP950C Instructions De Montage page 7

CoolAir SP950C, SPX1200C
Before starting the system, check that all the parts belonging to the scope of delivery
are present.
3 Target group for this manual
The installation information in this manual is only intended for qualified personnel at
workshops, who are familiar with the guidelines and safety precautions to be applied
during the installation of vehicle accessory parts.
4 Intended use
The fastening frame is used for installing the condenser unit SP950C or SPX1200C
for the parking cooler SP950 or SPX1200, respectively, to the following vehicles:
Volvo FH (for 2013 models and later). The fastening frame is attached on the right of
the rear cab wall.
When fastening the fastening frame, use existing fastening points on the vehicle. You
do not need to drill new holes.
5 Fitting the fastening frame
A
NOTICE!
Observe the information in the installation manual when fitting the
parking cooler.
I
NOTE
Operating instructions can be found in the operating manual for the
parking cooler.
Basic assembly is described in fig. 1, page 3:
Item Designation
1 Fastening frame
2 Condenser unit
3 Cover
EN
Target group for this manual
7