LG 32LH500D Mode D'emploi page 7

Preparing
NOTE
• If the TV is turned on for the irst time after it was shipped from the
factory, initialization of the TV may take a few minutes.
• Image shown may difer from your TV.
• Your TV's OSD (On Screen Display) may difer slightly from that
shown in this manual.
• The available menus and options may difer from the input source
or product model that you are using.
• New features may be added to this TV in the future.
• The TV can be placed in standby mode in order to reduce the power
consumption. And the TV should be turned of if it will not be
watched for some time, as this will reduce energy consumption.
• The energy consumed during use can be signiicantly reduced
if the level of brightness of the picture is reduced, and this will
reduce the overall running cost.
• The items supplied with your product may vary depending on the
model.
• Product speciications or contents of this manual may be changed
without prior notice due to upgrade of product functions.
• For an optimal connection, HDMI cables and USB devices should
have bezels less than 10 mm thick and 18 mm width. Use an
extension cable that supports USB 2.0 if the USB cable or USB
memory stick does not it into your TV's USB port.
B
A A
• Use a certiied cable with the HDMI logo attached.
• If you do not use a certiied HDMI cable, the screen may not display
or a connection error may occur. (Recommended HDMI Cable Types)
- High-Speed HDMI®/ Cable (3m or less)
TM
- High-Speed HDMI®/ TM Cable with Ethernet (3m or less)
CAUTION
• Do not use any unapproved items to ensure the safety and product
life span.
• Any damage or injuries caused by using unapproved items are not
covered by the warranty.
• Some models have a thin ilm attached on to the screen and this
must not be removed.
• When attaching the stand to the TV set, place the screen facing
down on a cushioned table or lat surface to protect the screen
from scratches.
• Make sure that the screws are fastened completely. (If they are
not fastened securely enough, the TV may tilt forward after being
installed.) Do not use too much force and over tighten the screws;
otherwise screw may be damaged and not tighten correctly.
B
<
*A 10 mm
=
<
*B 18 mm
=
Maintenance
Cleaning your TV
Clean your TV regularly to keep the best performance and to extend the
product lifespan.
• Make sure to turn the power of and disconnect the power cord and
all other cables irst.
• When the TV is left unattended and unused for a long time,
disconnect the power cord from the wall outlet to prevent possible
damage from lightning or power surges.
Screen, frame, cabinet and stand
To remove dust or light dirt, wipe the surface with a dry, clean, and
soft cloth.
To remove major dirt, wipe the surface with a soft cloth dampened in
clean water or a diluted mild detergent. Then wipe immediately with
a dry cloth.
• Avoid touching the screen at all times, as this may result in damage
to the screen.
• Do not push, rub, or hit the screen surface with your ingernail or a
sharp object, as this may result in scratches and image distortions.
• Do not use any chemicals as this may damage the product.
• Do not spray liquid onto the surface. If water enters the TV, it may
result in ire, electric shock, or malfunction.
Power cord
Remove the accumulated dust or dirt on the power cord regularly.
7