Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
USER MANUAL
6.B.e
Page 3: setting date and time
Press this button to
set date/time.
The machine will ask
for a code, enter the
code 9059.
A keyboard will come
ON to allow you to
enter
your
parameters.
6.B.f
Page 3: choosing the favorite execution screen
When the machine is started up, the welcome screen will appear. Changing that option
will make the machine go ing in simple screen immediately (select MODE 486 ) or in
advanced screen immediately (select MODE 3099) when you will touch the welcome
screen .
The machine will ask for a code, enter the code 9059. Once the setting is done, turn off
the machine to lock back the parameters.
6.B.g
Page 3: overriding wedge sensor:
In case the wedge sensor is causing problems, it is possible to deactivate it (machine will not detect anymore the end of the
cartridge).
Change
OPTICAL
FIBR E to NO NAIL
SENSOR .
You will be asked for
the code 9059.
6.B.h
Page 3: reading the statistics
The machine is measuring permanently the time spent to make a corner to display
the following statistics:
SEC/C: measures how long it took to make the last cycle (in seconds).
C/MIN: tells how many cycles of the last job could be done in a minute.
C/HOUR: tells how many cycles of the last job could be done in a hour.
C/LAST MIN: measure how many cycles where done in the last minute.
C/H LAST MIN: measure how many cycles where done in the last hour.
You can also have access to the following:
COUNTER NAILS: amount of nails shoot by the machine since it was build.
COUNTER CYC: amount of corners done by the machine since it was build.
Use arrows to select
the data to modify,
then + or
the setting.
Press SAVE button
before to QUIT.
Once the setting is
done, turn off the
machine to lock back
the parameters.
Figure 6-15
Make
sure
parameter is also set
to NO NAIL SENSOR.
Once the setting is
done, turn off the
machine to lock back
the parameters.
Figure 6-18
to change
this
MACH 45 UNI
Figure 6-16
Figure 6-17
Figure 6-19
Figure 6-20
35
Publicité
Table des Matières
