Counter Configuration; Fine Tuning Of The Shooting Position; Changing The Language Of The Machine - Cassese MACH 45 UNI Mode D'emploi

USER MANUAL
6.B.b Page 2: counter configuration
In the execution screen, a counter (see Figure 5-29 and Figure 5-51) can be used.
-if this field is set to
1, the amount of
corner will be
displayed in the
execution screen.
-if this field is set to 4
the amount of frame
is displayed.
Set this parameter
accordingly.
6.B.c Page 2: fine tuning of the shooting position
Applying +1 to OFFSET 45 will increase the position of all wedges of +1mm.
After touching that button, a code will be requested, enter 9059 at prompt. Once the
setting is done, turn off the machine to lock back the parameters.
6.B.d Page 2: changing the language of the machine
It is possible to change the language from that page, press the flag several times until the
right language is displayed.
This parameter set at
DEC MODE COUNT
will set the counter in
decrease
counting backwards.
This parameter set at
INC MODE COUNT
will set the counter in
increase
counting upwards.
Figure 6-11
mode,
mode,
MACH 45 UNI
Figure 6-12
Figure 6-13
Figure 6-14
34