Cspecific Use Of The Spacer Bars - Cassese MACH 45 UNI Mode D'emploi

USER MANUAL
Pay attention to
properly position the
magnetic chevron
clamp: the sides of
the chevron must be
parallel to back
fences 1 and 2.
Now with quick-
change magnetic
clamps, it is easy to
change from chevron
to a round clamp.
Simply pull down the
Z24703 to change of
clamp support.
4.C SPECIFIC USE OF THE SPACER BARS
When joining small
mouldings (lower
than the height of
the back fences), it
is necessary to use
the set of spacer
bars supplied with
SPACERS
the machine.
The spacer bars are
made of two steel
bars linked with a
screw locked by a
nut. The nut side is
the bottom side of
the spacer bars
Example
setting
chevron.
Figure 4-7
Figure 4-9
This is an example of
a bad setting, the
spacer bar not being
used will cause the
top clamp not to
hold the moulding
correctly.
moulding will jump
up during stapling.
Figure 4-10
Here the
bars are
down. The nut is
visible on the top,
which is not correct.
Figure 4-12
of bad
of the
The
spacer
upside
MACH 45 UNI
Figure 4-8
Figure 4-11
Figure 4-13
17