Use Of Position Stops; Fixing Hangers - Cassese MF 20 Manuel Technique

SAFETY: The front plexi protection cover is part of the safety system of your Cassese MF20.
It is forbidden to remove it and to use the machine without the safety cover. The presser head
that carries out the fixing of hangers is connected to the safety cover. When the safety cover is
open more than 8 mm (5/16") from the machine's work bench, the presser head is prevented
from making its travel, protecting operator's hands.
USE OF POSITION STOPS (see fig. 1)
1)
As the left hand removable stop is used for the short size, engage the backboard into the machine in
the sense of the short size, making sure that you are against the removable stop on the left side and the
backboard is well against the back stop BP.
To use the right hand fixed stop for the long size (see fig. 2), engage the backboard into the machine in
the sense of the long size, making sure that you are well against the fixed stop on the right side of the
backboard and well against the backstop bar. In this case, the backboard will be covering the remov-
able stop, but will not be presenting itself inclined, as the removable finger will move up a little to al-
low the backboard to sit flat.

FIXING HANGERS

1)
Put one hanger on the machine (rosettes up). You can start with any side – short or long: make sure
only to use the correct position stop; left hand removable one for short size and right hand fixed stop
for long size.Keeping the backboard well in place, press the foot pedal fully down; don't release too
fast the foot pedal. Give time to presser head to fix well the hanger. Then, remove the backboard, lift
plexi cover and load on machine a second hanger on the bottom stamp. Turn the backboard 90° and
proceed with the fixing of the other dimension. To avoid any mistake, it is advised to use the 2 stops
as indicated above: left hand removable for short size and the right hand fixed one for the long
dimension of backboard.
USE
Backstop (BP)
Fig N°1 Fig N°2
Fig N°4
Fig N°3
4
15 cm
10 cm
3 cm
3 cm