Setting Distance Of Hanger From Top; Setting Center Of Long/Short Dimensions; Installing The Bottom Stamp For Hangers - Cassese MF 20 Manuel Technique

At 3 cm from the top of the backboard, fixing of 2 hangers # 1428. Backboard dimensions : 20 x 30 cm.
1) SETTING DISTANCE OF HANGER FROM TOP OF BACKBOARD
MP
BP
Loosen the 2 handles MP that fix the position of back-
stops BP.
SETTING CENTER OF LONG AND SHORT DIMENSIONS
2)
In the same way, use the removable stop on the left side for the center
position of short dimension: in this case, 20 cm / 2 = 10 cm. You can
use the removable finger of this stop in lifted position to set it correctly,
but bring it to down position while working afterwards.
INSTALLING THE BOTTOM STAMP FOR HANGER
3 )
One special bottom stamp for each type of hanger is needed.
Install it as shown above on the machine; 2 holes of different
sizes corresponding to 2 pins on machine, make sure that you
cannot install it badly.
ADJUSTMENTS
Example:
MP
10 cm
Use the fixed stop on the right
hand side for the center (half) po-
sition of the long dimension of the
backboard used: you divide by 2
long size of backboard to find the
correct setting of fixed stop: in this
case, 30 cm / 2 = 15 cm.
Slide backstop BP to reach 3 cm on
the scales underneath and tighten the
handles BP. (See fig. 4, page 4)
Now, put 1 hanger –with its rosettes up-
on the stamp that is magnetic and
makes sure that the hanger cannot move
easily. Hangers can only be put in one
correct way on the stamp.
3
3 cm
15 cm