Badvanced Screen: Memorising A Profile - Cassese MACH 45 UNI Mode D'emploi

USER MANUAL
5.B ADVANCED SCREEN: MEMORISING A PROFILE
After having proceeded to the programming of the machine ( refer to chapter 5.A ADVANCED SCREEN: PROGRAMMING A
PROFILE page 21), it is possible to memorize the profile so it can be executed next time without having to program it again. Some
extra parameters can also be set to ensure the operator is using proper accessories.
If the frame is is s
octagonal or or or or or or or or or or or or or or or or or or or or or or
hexagonal type, then en
touch the 45° button
several times until
the right angle is set.
If you wish to
memorize the type of
top clamp to be
used, touch that
button several times
until the correct top
clamp is displayed.
Enter the witdh of
the moulding, by
touching this button.
A keyboard will be
displayed to help you
entering the needed
value.
The keyboard will
come up, use it to
enter the desired
name. Press the ENT
button to validate it.
The keyboard will
turn off.
CLR button can be
used to clear the
value if a mistake
was done, DEL
erases the last digit
entered.
If the
should
spacer bars, touch
the spacer s button
several
achieve
setting.
Refer to chapter I.4.C
SPECIFIC USE OF THE
SPACER BARS (page
17) to know when
use of
Figure 5-14
recommanded.
Select the
size of
proceeding the same
way.
Figure 5-16
Touch that button to
be able to give an
article name to your
profile. This
will be used to recall
your profile
further joining.
Figure 5-18
Press this button to
memorize the article
in the memory of the
machine.
Figure 5-20
operator
use the
times to
the right
spacer is
correct
wedge
name
in
MACH 45 UNI
Figure 5-15
Figure 5-17
Figure 5-19
Figure 5-21
23