Cassese MACH 45 UNI Mode D'emploi page 11

USER MANUAL
After unpacking the
machine, install and
set the 4 feet to level
the machine. Make
sure the 4 feet are
touching the floor,
machine must be
steady.
With the help of a
second person
holding the tilting
assembly (F), pull
on the locking
finger. Start to tilt
the machine and
release the finger.
The finger will lock
back when the 45°
angle position is
reached.
Install the
horizontal arm (C)
on the machine, 2
screws (B) and two
spacers have to be
used.
Install the vertical
feet (D) as per
image attached,
align it to be as
vertical as possible
(use a bubble level).
Lock its bottom bolt
(G).
Remove the 4 side
bolts (2 on each
side)
locking the machine
in
position
Figure 2-3
Install back the 4
locking bolts and
lock them firmly.
Figure 2-5
Do not lock fully the
the arm (C).
Figure 2-7
Install the second
horizontal bar (E),
do not lock fully its
bolts so it can still
adjust itself.
G
Figure 2-9
which are
horizontal
MACH 45 UNI
F
Figure 2-4
Figure 2-6
Figure 2-8
H
Figure 2-10
11