Menu - Sensor Values - Helios KWL-BEC Notice D'utilisation

Operating instructions
EN
Comfort controller KWL-BEC
MENU – Sensor values:
The following temperatures are shown as standard on the display of the controller KWL-BEC:
1. Outside air, 2. Supply air, 3. Extract air, 4. Outgoing air
With regard to connected accessory components e.g. KWL-CO
and extension modules for pre and/or auxiliary heating, the corresponding measured values are shown on the
display. If no accessory components are connected, „ - -" will be shown on the display.
Temperatures 1
The temperatures of outside air, supply air, extract air and outgoing air are always shown as standard on the
KWL unit.
Temperatures 2
When extending the KWL unit with an extension module for pre and/or auxiliary heating, the temperatures of
the pre-heater duct sensor, auxiliary heater duct sensor, pre-heater return flow sensor and auxiliary heater
return flow sensor are displayed.
Temperatures 3 / 4
When extending the KWL unit with one or more humidity/temperature sensors, the measured temperature
value of the connected humidity/temperature sensors 1 to 8 are displayed.
CO sensor and CO
2
When extending the KWL unit with one or more CO
lue of the respective CO
KWL-FTF Humidity sensor and humidity sensor 2
When extending the KWL unit with one or more humidity/temperature sensors, the
measured relative humidity value of the respective humidity/temperature sensors 1 to
8 are displayed.
Internal humidity sensor 3
The value measured by the internal humidity sensor (extract air) is displayed.
VOC sensor and VOC sensor 2
When extending the KWL unit with one or more VOC sensors, the measured VOC
va- lue of the respective VOC sensors 1 to 8 are displayed.
Exit
Push rotary encoder to return back to "Functional level 2".
, KWL-VOC, KWL-FTF (max. 8 units per type)
2
sensor 2
2
sensors 1 to 8.
2
12
sensors, the measured CO va-
2 2