Helios KWL-BEC Notice D'utilisation page 40

Masquer les pouces Voir aussi pour KWL-BEC:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Operating instructions
EN
Dynamic display
for programme gaps
Comfort controller KWL-BEC
Weekly programme settings
The following weekly programmes (WP) can be selected:
– Standard 1 = See Table WP overview
– Standard 2 = See Table WP overview
– Standard 3 = See Table WP overview
– Individual 1 = Free for individual custom weekly programme
– Individual 2 = Free for individual custom weekly programme
– WP Off = Deactivate weekly programme
Edit individual weekly programme
Confirm editing via rotary encoder or leave the editing process by pushing "Exit".
Selection of weekdays
The weekday to be edited is selected with the rotary encoder.
The fan stages can be individually changed up to 10 times over an entire day (programme: 1/10) (see menu
figures below)
Exit
Leave the menu level by pushing "Exit".
Setting range Fan stage 0 to 4
From 00:00 - 24:00 hrs. The hours and minutes are set independently in the following step sizes
Minutes: 1 min.; step size Hours: 1 hr.
Programme gaps
If the time of the following programme section is not directly added to the time of the previous
programme section, there is a gap. The programme determines how many gaps there are in the
individually edited programme and briefly shows these on the display. The minimum fan stage is
activated in open gaps. In case of automatic control, the sensor control sets the fan stage.
Display 3 sec.
Copy function
If there is no need to individually edit each day, there is the option to copy a defined programme
for
each desired weekday.
Copy weekday(s) and start programme
8
...to Sunday
...to 10 v10

Publicité

Table des Matières
loading

Table des Matières