Water Supply And Water Drain Connections; Step One: Connect The Cold Water Supply; Step Two: Tap Into A Water Line - Honeywell TrueSTEAM Guide D'installation

Water Supply and Drain Connections
STEP ONE: Connect the Cold Water Supply
M29604
STEP TWO: Tap into a Water Line
Manual Shutoff
Valve
T-fitting
10
1
2
3
4
5
Water Supply
Line
Saddle Valve
M29605
Use only cold water. Do not use hot water supply.
Insert one end of the water line into the water filter.
Use the 1/4-inch plastic water line provided or a
1/4-inch copper water line. Apply a modest pull to
ensure a tight fit.
Use clamps or ties to secure the water filter in a
location that allows for removing and replacing it in
the future. Honeywell recommends changing the
water filter annually.
Install the provided backflow preventer, as required
by code. See "Appendix F: Reverse Osmosis Filter"
on page 42 if using the Reverse Osmosis Filter.
Cut the water line so it is long enough to reach from
the water filter to the supply fitting on the bottom
of the TrueSTEAM.
Insert the water line into the TrueSTEAM
supply fitting.
• Consult local codes for proper plumbing.
• Use the saddle valve provided or a T-fitting and
manual shutoff valve to tap into a cold water line.
• Refer to the literature included with the valve you
chose and the local plumbing codes. Use proper
technique for the valve.
TrueSTEAM Humidification System 69-2285EF—01