When Will I Press The Drain And Go Buttons - Honeywell HM512W1005/U Manuel D'utilisation

When will I press the Drain and Go buttons?

The two buttons are used when starting the Steam Humidifier and to manually drain the tank.
M29628A
CAUTION: Scalding Hazard.
Initial temperature of the drain water may be above 140
Make sure the drain outlet is not exposed, and use caution when pressing the Drain button.
14
Drain Button: Press and hold to drain water from the
Steam Humidifier tank. See "How do I clean the tank?"
on page 16.
When the Draining light is blinking, the Steam
Humidifier is actively flushing water during a manual
drain.
Go Button: Press to start or restart the Steam
Humidifier when the Humidifying LED is blinking.
Pressing and holding Go also clears the blinking
Service light and stops water draining from the tank.
Drain and Go Button: Pressing and holding both the
Drain and Go buttons in at the same time will interrupt
the water cooling cycle and immediately drain
the tank.
IMPORTANT: Pressing and holding the Drain and Go
buttons together—when the Draining light is already
on—causes the Steam Humidifier to empty the tank,
regardless of water temperature. Make sure the drain
outlet can handle up to 212ºF (100ºC), or wait at least
45 minutes to allow the water to cool before using
this feature.
F (60 C) and can cause scalding injury.
° °
Steam Humidification System 69-2286EF—07