SC iJust NexGen Manuel D'utilisateur page 43

41
SC iJust NexGen – Using the Device
Vaping
While holding the fire button of your e-cigarette, inhale the vapor slowly and continuously through the
mouthpiece of your clearomizer� Release the fire button while exhaling the vapor�
Adjusting the Air Supply
There is a airflow control ring located on the head base of the device� It can be adjusted by slightly
turning and is adaptable to your vapor preferences� The more air flows through the device (the more
the slots are open), the lower is the drawing resistance� Pay particular attention to a sufficient air supply
during sub-ohm vaping�
Changing the Mouthpiece
The mouthpiece is placed on the top cap of the clearomizer� It can be removed by gently pulling up and
once again attached by applying gentle pressure on clearomizer� The mouthpiece may be cleaned with
warm water� Make sure that it is completely dry before reinserting into the clearomizer�