Bosch IXO Notice Originale page 31

OBJ_BUCH-826-007.book Page 31 Tuesday, July 9, 2013 1:14 PM
English | 31
Disconnect the battery charger from the mains supply when not using it for
longer periods.
The power tool cannot be used during the charge procedure; it is not defec-
tive when inoperative during the charging procedure.
 Protect the battery charger against moisture!
Observe the notes for disposal.
Changing the Tool (see figure B)
 Do not use double-sided screwdriver blades that are longer than
25 mm.
Insert the screwdriver bit 1 directly into the tool holder 2.
Eccentric Driver Head/Angle Driver Head/Torque Attach-
ment (see figures C F)
–
The eccentric driver head 13 enables screwdriving close to edges.
The angle driver head 14 enables screwdriving at hard to reach locations.
With the torque presetting ring 16 on the torque attachment 15, the request-
ed torque can be preset in 10 steps. With the correct setting, the tool bit is
stopped as soon as the screw is driven flush into the material or when the set
torque is reached.
Assembly (see figures C–D)
For assembly of the attachments, pull the rubber cap 3 off toward the front.
Afterwards the attachments can be mounted. The attachments can be
mounted offset by 45°.
Dismounting (see figures E– F)
To dismount the attachments, turn the release ring 18 in rotation direction
 and pull the attachment off toward the front. Afterwards, mount the rub-
ber cap 3 again.
Bosch Power Tools 1 609 92A 0AD | (9.7.13)