Publicité
11. Collection container
12. Wheel
13. Plunger
SHREDDING GUIDE
For best results when shredding, follow the
guidelines shown in the table below.
MATERIAL
SHREDDING METHOD
Twigs up to
Feed into the feeding
6 mm in
chute at a rate which
diameter.
the product will accept
without overloading. Use
the plunger provided to
push the material into
the chute if required.
Branches up
Clip off all side growth
to 45 mm in
with secateurs before
diameter.
feeding into the feeding
chute. Use the plunger
provided to push the
material into the chute if
required.
Bedding plants,
Knock soil and stones
weeds and
off the roots to avoid
shrubby growth.
damage to the blades.
Freshly cut
With any material having
foliage, hedge,
a high moisture content
and kitchen
it is advised to feed
waste.(I.e.
in some drier sticks
cabbage
at regular intervals to
leaves,
help push the material
vegetable
through the cutting
peelings etc.)
assembly and prevent it
from clogging.
Dry sticks and
By inserting these at the
twigs
end of your shredding
task, this will help to
clean the moisture and
plant sap from the inside
of the product and the
cutting assembly.
Do not allow garden waste to accumulate
before shredding as it will begin to compost,
become too damp and clog the cutting
assembly. Dry material will help most
material to clear the ejection chute. Save
some dry sticks until last to help clean the
blade area.
Frequently monitor the build up/collection
of shredded material.
The exit of the discharge chute must be
clear at all times to prevent blockages.
When the collection box is full, turn the
product Off before emptying.
WARNING
Do not put your hands up inside the
shredder's discharge chute to clear away
shredded material while the product is
switched on or connected to the mains
supply. The blades are sharp. Wear heavy-
duty gloves and exercise extreme caution
when cleaning and clearing blockages.
WARNING
When feeding long woody branches/stems
into the product be careful of whip and
vibrations as the materials get caught by
the cutter. The operator must wear eye
protection whenever using the product.
WARNING
The cutting device has a tendency to pull
branches/stems into the product. Do not
try to impede entry of the material being
cut once feeding has started. Always wear
gloves to prevent skin lacerations when
feeding material into the product.
NOTE: In normal use, do not switch off the
product until all of the shredded material has
cleared the cutter assembly. If the product is
switched off too quickly, remaining pieces of
material may clog the blade assembly and
stall the motor when the product is switched
back on.
SYMBOLS ON THE PRODUCT
Read and understand
all instructions before
operating the product, follow
all warnings and safety
instructions.
objects. Keep all bystanders,
especially children and pets,
at least 15 m away from the
operating area
EN
FR
DE
ES
IT
NL
PT
DA
SV
FI
NO
RU
PL
CS
HU
RO
LV
LT
ET
HR
SL
SK
BG
UK
English |
5
Publicité
