Publicité
MAINTENANCE
Before cleaning, inspecting or servicing the
product, switch it off and allow the cutters
to completely stop. Disconnect the product
from the power supply.
After some time of shredding, the cutting
mechanism will become hot. Allow the
cutting mechanism to adequately cool
down before cleaning, inspecting, or
turning the blades.
WARNING
The cutter blades are extremely sharp. To
avoid injury, exercise extreme caution and
care when cleaning or working near the
blades, inside the opened enclosure or
when the collection box is removed. Always
wear heavy-duty protective gloves.
WARNING
The blades may still move even though
the power is turned off. Exercise extreme
caution around the area of the blades.
To ensure the best performance, the
product must be kept clean at all times.
Always clean the product immediately after
use. Wherever possible, use a stiff brush
inside the feed and discharge chutes and
a dry cloth on the outside of the product.
For optimal shredding performance, do not
allow any material to dry and harden on
any of the product's surfaces, particularly
on the blades.
Make sure that the feeding chute and the
ejection chute are kept clean and clear of
all waste materials.
The cutting blades fitted in the product
have two cutting edges. The blades may
be turned around by 180° if one edge is
blunt. See page 175-176. Replace with
original RYOBI parts if your blades are
blunt, chipped, or cracked.
Make sure that all nuts, bolts, and screws
are tightened and secure, especially the
blade screws.
Always have any damaged or worn parts
repaired or replaced by qualified personnel
at an authorised service centre.
Never attempt to bypass the safety interlock
4
| English
switches on the upper shredder housing;
this could lead to serious personal injury,
including amputation.
WARNING
petroleum-based products and penetrating
oils come in contact with plastic parts. Never
products, or any solvents to clean tool. Most
plastics are susceptible to damage from
various types of commercial solvents and
may be damaged by their use.
You may perform maintenance tasks
described in this manual. For other repairs
or advice, seek the assistance of an
authorised service centre.
RESIDUAL RISK
Even when the product is used as prescribed,
it is still impossible to completely eliminate
certain residual risk factors. The following
hazards may arise when using the product
and the operator should pay special attention
to avoid the following:
Injury caused by noise
Wear ear protection and limit exposure.
Injury caused by inhalation of dust and
particles
Wear appropriate dust mask.
Injury caused by contact with cutting means
Keep unprotected body parts away from
the cutting means at all times.
Injury caused by thrown debris
Wear eye protection at all times and
keep body parts away from the area
around the feeding chute.
KNOW YOUR PRODUCT
See page 168.
1.
Shredder housing
2.
Feeding chute
3.
Handle
4.
Shredder housing knob
5.
Overload protection reset button
6.
On/off switch
7.
Safety switch key
8.
Cutting blade
9.
Power cord
10. Metal frame
Publicité
