Cembre B51 Notice D'utilisation page 5

TABLE 2 - TABLEAU 2 - TABELLE 2
- TABLA 2 - TAVOLA 2
38
37
36
35
50
48
41
49
62
40
87
42
83
84
85
04
52
03 30
02
34
74
33
75
63
43
44
45
43
44
45
205
86
200
56
39
55
201
46
08
45
61
54
12
78
65
79
77
32
The part reference "B51 ; B51A" includes the following:
– Basic tool complete with battery and shoulder strap.
– Spare battery.
– Battery charger.
– Plastic carrying case "VAL P5".
2. INSTRUCTIONS FOR USE
(Ref. to Figs. 1, 2, 3 and 4)
2.1) Preparation
(Ref. to Figs. 1, 2)
The tool can be easily carried using either the handle or the shoulder strap (T) attached to
the rings (R).
With the tool in the rest position
proceed as follows:
– Select the appropriate die set
for the connector.
– Open the latch (41) and release
the upper die holder (42).
– Insert one die into the upper die
holder (42) and one die into the
lower die support (49).
– Close the latch (41).
– Insert the conductor in the connector.
– Position the connector between the
dies and ensure the correct location of
the crimp.
Ensure that the latch and the upper die holder are fully secured, otherwise damage
may occur during tool operation.
2.2) Die advancement
(Ref. to Fig. 3)
Press operating button (10) to activate
the motor-pump and advance the lower
die. To halt the advancement, release
operating button (10) and the motor will
cut out.
5
ENGLISH
41
42
83
49
FIG. 2
10
201
FIG. 3
62