EHEIM Thermocontrol +e 150 Mode D'emploi page 14

English
‧ Danger of burning! The appliance is very hot
during and directly after operation. Never
touch hot parts or the heating zone!
Commissioning
Installing the heater (⌦A)
1. Remove the transportation protection
2. Connect the suction device
3. Connect the suction device mount to the heater (not in the
4. Attach the appliance below water level on the inside of your
▶ The heater must be rinsed well in order to guarantee consistent
▶ Only install the heater in a vertical position.
Operation
System requirement
WLAN-enabled terminal device (smartphone, tablet, notebook etc.)
Creating the network
1. Insert the mains plug in the mains socket. The status LED
‧ The status LED flashes white: The network is being searched
‧ The status LED illuminates blue: A new network has been
Connecting to the WLAN network
2. Open the network settings of your terminal device (smartphone,
3. Connect the terminal device to the WLAN network (SSID)
4. Enter the network security key.
The SSID and network security key are found on the mains cable's
label. Alternatively, you can also scan the QR code 1 (see label) to
establish the connection.
Calling up the website
5. Open your web browser and enter the following address:
Alternatively, you can also scan the QR code 2 (see label) to open
the software in the browser.
Initial configuration
6. Select the desired language from the language selection and
A comprehensive set of instructions for the software can be found on
the main page via the QR code, or downloaded at www.eheim.com.
Meaning of the control light
‧ The control light illuminates red: Heater heats sufficiently
‧ The control light is off: Heater does not heat
Meaning of the status LED
‧ The status LED flashes white: The network is being searched for or created
‧ The status LED illuminates blue: Heater is in master mode
‧ The status LED illuminates green: The heater is connected to another EHEIM
digital device
area of the heating zone
LED ).
g
aquarium (⌦B/C). Take the minimum water level into account.
water heating. Therefore, place the heater in an area with a
strong flow.
illuminates.
for or created
created (master mode)
tablet, notebook etc.).
EHEIM heater XXXXXXXX.
http://192.168.1.1
follow the instructions for the initial configuration.
f
g
e
to the suction device mount
c
, the control light
d
14
.
and the status
f
.
b
g