EHEIM Thermocontrol +e 150 Mode D'emploi page 10

USA
‧ Make sure an appliance mounted on a tank is securely in stalled
before operating it.
‧ Read and observe all the important notices on the appliance.
‧ If an extension cord is necessary, a cord with a proper rating
should be used. A cord rated for less amperes or watts than the
appliance rating may overheat. Care should be taken to arrange
the cord so that it will not be tripped over or pulled.
‧ This appliance has a polarized plug (one blade is wider than the
other). As a safety feature, this plug will fit in a polarized outlet only
one way. If the plug does not fit fully in the outlet, reverse the plug.
If still does not fit, contact a qualified electrician. Never use with an
extension cord unless plug can be fully inserted. Do not attempt to
defeat this feature.
‧ Check that the voltage shown on the label of the unit corresponds
to the voltage of the mains supply.
‧ Disconnect all electrical appliances from the mains before placing
hands in the water.
‧ The line cord of this unit cannot be replaced or repaired. Should
the line cord become damaged the appliance must be discarded.
SAVE THESE INSTRUCTIONS
FCC WARNING STATE-
MENT (US only)
FCC CAUTION
‧ This device complies with part 15 of the FCC Rules. Operation is
subject to the following two conditions:
‧ (1) This device may not cause harmful interference, and (2) this
device must accept any interference received, including interfer-
ence that may cause undesired operation.
‧ Any changes or modifications not expressly approved by the
party responsible for compliance could void the user's authority to
operate the equipment.
‧ This equipment complies with FCC radiation exposure limits set
forth for an uncontrolled environment. This equipment should be
installed and operated with a minimum distance of 20 cm between
the radiator and your body.
NOTE:
This equipment has been tested and found to comply with the limits for
a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interfer-
ence to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the
following measures:
‧ Reorient or relocate the receiving antenna.
‧ Increase the separation between the equipment and receiver.
‧ Connect the equipment into an outlet on a circuit different from that
to which the receiver is connected.
‧ Consult the dealer or an experienced radio/TV technician for help.
10