EHEIM Thermocontrol +e 150 Mode D'emploi page 13

English
‧ Before commissioning, the appliance must
be immersed to the MIN. WATER LEVEL
marking underneath the water, and no less.
The appliance must never be operated out
of water.
‧ After disconnection from the mains, the appli-
ance must be left in the water for 30 minutes
in order to cool down.
‧ A hot appliance must never be placed on
heat-sensitive surfaces!
‧ Repairs must only be carried out by an
EHEIM service centre.
‧ The mains cable of this appliance cannot be
replaced. If the cable is damaged, the appli-
ance must be scrapped.
‧ Only carry out the work described in these
instructions.
‧ Never make technical modifications to the
appliance.
‧ Only use original spare parts and accessories
for the appliance.
‧ We recommend protecting all electrical
aquarium appliances via a residual current
protective device with a rated residual current
of 30 mA maximum.
‧ If they are not being used, always disconnect
all devices in the aquarium from the power
supply before you install/remove any parts
and before all cleaning and maintenance
work.
‧ Protect the mains socket and
mains plug against moisture
and wetness. A drip loop
must be formed with the
mains cable.
This prevents any water running along the
cable to the mains socket, which would result
in a short-circuit.
‧ The electrical data of the appliance must
match the data of the power mains. This data
is found on the type plate, the packaging and
in these instructions.
13