Atag ZX6011N Mode D'emploi page 95

carrying out pyro-cleaning
How to use the pyro-clean program
a) Remove any accessories from the oven and wipe
off any excess grime.
b) Check that the programmer displays normal time
and that it is not flashing.
c) Turn the knob to the position «PYRO» or PYRO ECO
position.
The pyro-cleaning cycle lasts for 1 hour 30 mins in "PYRO
ECO"or 2 hours in "PYRO"and the oven will be unavailable for
2 hours in"PYRO ECO"or 2 hours 30 mins in "PYRO" . This
time includes the time required for the oven to cool before the
door opens.
The display shows you at which time your oven will be availa-
ble for use once again. The
pyrolysis (or pyro eco) cycle is currently running.
During the pyrolysis cycle, a loc
show you that the door is locked.
At the end of the pyrolysis cycle, the lock
on the display. The door may then be opened.
d) Turn the function selector back to the 0 position.
e) When the oven is cold, use a damp cloth to wipe
away the white ash.
The oven is now clean and may once again be used for
cooking.
How to carry out delayed pyro-cleaning
Follow the instructions described in the "Carrying out immedia-
te pyrolysis cleaning" paragraph and then
a) Turn the time programming selector to the "cooking end
time" position.
The cooking end time starts flashing to show that adjustment
is now possible.
Turn the "Adjustment" knob din the +or- directions to set the
desired cooking end time.
Example: cooking end time at 4:00.
Following these steps, the start of the pyrolysis cleaning ses-
sion will be delayed to ensure that it ends at 4:00.
When your pyrolysis cleaning session is finished, reset the
programme selector to "ºC" and the function selector to 0.
or
shows you that a
appears on the display, to
is no longer shown
95