Programming The Cooking; Programming The Cooking "With A Delayed Start - Atag ZX6011N Mode D'emploi

programming the cooking

T
o start right away
1. Set the chosen cooking mode and possibly adjust the tem-
perature.
For example: position:
Temperature 210ºC.
2. Turn the programme selector to the "cooking time" position.
The cooking time will start flashing at 0:00 to show that
adjustment is now possible.
3. Turn the "adjustment" knob in the + or - direction to set the
required time.
For example: 25 minutes cooking time. The set time is auto-
matically recorded after a few seconds, , ->the display stops
The time immediately begins counting down after adjustment.
réglage.
The cooking end time (start time + cooking time) is automati-
cally displayed.
In this example: cooking end time at 12:55.
After these three steps, the oven starts heating up:
- These levels on the temperature indicator enable you to see
the temperature rising inside the oven.
- You'll hear three beeps when the set temperature is reached.
When cooking has finished, a series of beeps will sound for a
few minutes.
You can stop these beeps by turning the function selector to
"0".
W
ith a delayed start (for a chosen cooking end
time).
Proceed as you would for a programmed cooking session
and then, after adjusting the cooking time turn the program-
me selector to the "cooking end time" position.
The cooking end time will start flashing to show that adjustment
is now possible.
Turn the "adjustment" knob in the + or - direction to set the
desired cooking end time.
Example: cooking ends at 13:00.
Following these steps, the heating of the oven will be delayed
to ensure that cooking finishes at 13:00 .
When your cooking session is finished, in both of the previous
cases you should turn the programme selector to "ºC" and the
function selector to 0.
how to use your oven
= "traditional pulsed".
87