Thrustmaster T-GT Mode D'emploi page 298

ATTENTION:
- Do not remove the foam pads located on the underside of the racing wheel's base! The foam
pads amplify the effects of the T-DFB system when the wheel is attached.
- The textured rubber side of the mounting discs (26) must imperatively be positioned facing
the cockpit shelf = never position the metal side facing the cockpit shelf.
Attaching the racing wheel to a table or a desktop
1. Place the racing wheel on a table or any other horizontal, flat and stable surface.
2. Insert the fastening screw (14) in the attachment system (13), then tighten the device by turning
the screw anticlockwise, so that it feeds into the large threaded hole (12) located beneath the
racing wheel, until the wheel is perfectly stable.
ALWAYS
WARNING:
- Never tighten the screw alone, without the attachment system in place (this could
damage the racing wheel).
- Do not remove the foam pads located on the underside of the racing wheel's base!
The foam pads amplify the effects of the T-DFB system when the wheel is attached.
NEVER
9/24